J'S RACING S2000 Front camber joint w/ roll center S2

Newly designed J’s Racing Camber Joint  CAJ-S1-S2

By redesigning the previous model, the new camber joints have been enhanced with the roll center adjuster function in addition to the original negative camber adjustment.

Material : Forged aluminum 6061

The surface is anodized red with a laser carved ‘J’s Racing” seal

Ball joint  S45C

Boll stud  SCM435 HB195-260,  Fluctuation angle 33 degree all around

The front camber angle can be adjusted to the stock + 3 degree

The front roll center value can be adjusted back to the correct one.

The insufficient negative camber is always a problem for S2000. This product creates enough negative front camber by locating the lower ball joint at an eccentric angle from the center.

The product also corrects the front lower arm position back close to horizontal, so that the correct geometry is restored with the accurately adjusted roll center. 

[When you reduce the ride height, the front lower arm position becomes like a separated letter V]

It works in a variety of driving situations from the street to the race track.

It is a must-have item for a spirited sport driving with S2000.

Safety precautions

Adjustable range:  3 to 5 degrees

Ride height:  Recommended to the vehicle whose height is reduced more than 40mm

Included in the kit:

Camber Joint S1  x2

Clip   x2

Castle nut   x2

* The stock bolts are to be reused or use new stock ones.

Please apply the correct tightening torque.  After the installment, it is necessary to properly adjust the ride height and alignment.

It is highly recommended to check the tightening condition of the bolt & nut periodically.

[Always check it before the track event or race]

Shipping is about 60-90 days