Platinum Pro Plug-In ECU R32/R33 Skyline

If you are after a simple plug-and-play option and your car still has its original engine and wiring in it, a Plug-in ECU is the easiest and quickest solution. You simply unplug the factory ECU, and plug the Haltech ECU directly into the factory harness. Load your base map and you're ready to go!

Direct plug and play replacement of the OEM ECU, no re-wiring necessary.

Uses the cars factory sensors

Supports R32 GT-R twin MAF sensors

Supports Sequential Injection (peak and hold) and Direct fire ignition

Windows 2000, XP, Vista, Windows 7 compatible software

Real time programming, instant hesitation free adjustment while engine is running

Fully user definable 32 x 32 mapping

Tuning via Volumetric Efficiency (VE), Injection time or Lambda Correction (MAF)

OBD II Code Storing & Malfunction Indicator Light (MIL) Control (through laptop only )

Selectable onboard internal MAP sensor rated to 150kPa (up to 1.5 Bar or 22psi boost)

Wideband “auto tuning” using user definable target AFR table

Flex Fuel Support

USB and CAN Communication Port

IMPORTANT EMISSIONS NOTICE:

In many states, it is unlawful to tamper with your vehicle's emissions equipment. Haltech products are designed and sold for sanctioned off-road/competition non-emissions controlled vehicles only and may never be used on a public road or highway. Using Haltech products for street/road use on public roads or highways is prohibited by law unless a specific regulatory exemption exists (more information can be found on the SEMA Action Network website www.semasan.com/emissions for state by state details in the USA). It is the responsibility of the installer and/or user of this product to ensure compliance with all applicable local and federal laws and regulations. Please check with your local vehicle authority before purchasing, using or installing any Haltech product.

Suits: Nissan R32/33 GTS-T and GTR. Manual transmission only.

Includes: Platinum PRO Direct Plug-in ECU, Plug and pins for auxiliary I/O harness. Haltech CAN adaptor cable DTM-4 female receptacle/socket to 8 pin black Tyco 3""/75mm (used to adapt a Platinum series ECU to a DTM-4 Elite CAN system), USB programming cable and USB Software Key.

Notes: Directly accepts an input from a flex fuel sensor.h

SUPPORTED OEM FUNCTIONALITY:

Boost Control

A/C Output

Idle Control

Thermofan

VCT Switched ( N-VCT)

Check Engine Light

Fuel Pump Control Module

MAF Sensors

Narrowband Sensors

Vehicle Speed

Air temperature Sensor (GTR Only)